ASVAB Electronics Information Practice Test 863540 Results

Your Results Global Average
Questions 5 5
Correct 0 3.45
Score 0% 69%

Review

1

In electrical wiring, which of the following are proportional?

50% Answer Correctly

the diameter of the wire and the amount of the voltage

the diameter of the wire and the amount of the current

the length of the wire and the amount of the voltage

the length of the wire and the amount of the current


Solution

Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.


2

In household electrical wiring, which color of insulation indicates the 'hot' wire?

51% Answer Correctly

black

green

red

white


Solution

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.


3 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
1080 W
1203 W
1200 W
3600 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.

4 Use Ohm's Law to calculate the value of voltage in this circuit if resistance is 100 Ω and current is 9.5 amps.
85% Answer Correctly
951.5 V
950 V
475 V
855 V

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

V = \( I \times R \) = \( 9.5 \times 100 \) = 950 V


5

The ampere is a unit of measurement for:

79% Answer Correctly

inductance

current

energy

power


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.