A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.

Voltage (V) is the electrical potential difference between two points. A voltmeter is used to measure the voltage between two points in a circuit.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.

Connecting the 4 batteries in series multiplies their voltage while keeping their current the same yielding a 60V 25A configuration. Connecting the 4 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 15V 100A configuration. Using a series-parallel connection, 2 batteries can be connected in series and 2 can be connected in parallel resulting in a 30V 50A configuration.