Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.

Connecting the 10 batteries in series multiplies their voltage while keeping their current the same yielding a 120V 5A configuration. Connecting the 10 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 12V 50A configuration. Using a series-parallel connection, 5 batteries can be connected in series and 5 can be connected in parallel resulting in a 60V 25A configuration.

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.