| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.01 |
| Score | 0% | 60% |
In household electrical wiring, which color of insulation indicates the 'hot' wire?
white |
|
black |
|
green |
|
red |
In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.
Alternating current changes __________ many times each second.
resistance |
|
frequency |
|
direction |
|
period |
In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.
In an electronic circuit, a thermocouple can be used to:
link the temperature of one component in the circuit to that of another component in the circuit |
|
increase or decrease the temperature of a component in the circuit |
|
open or close a circuit at a designated temperature |
|
keep the circuit at a designated safe temperature |
A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.
What is the primary difference between a rectifier and an inverter?
a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion |
|
a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion |
|
a rectifier converts a DC input to AC while an inverter converts an AC input to DC |
|
a rectifier converts an AC input to DC while an inverter converts a DC input to AC |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.
Electrons will flow as current from areas of __________ potential (concentration of electrons) to areas of __________ potential.
low, low |
|
high, low |
|
high, high |
|
low, high |
Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.