ASVAB Electronics Information Practice Test 960956 Results

Your Results Global Average
Questions 5 5
Correct 0 3.09
Score 0% 62%

Review

1

Which of the following is a characteristic of batteries connected in parallel?

52% Answer Correctly

one connection is made between each adjacent battery

total current equals the average of the individual battery currents

the positive terminal of one battery is connected to the negative terminal of the next

total current equals the sum of the individual battery currents


Solution

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in parallel are that total voltage equals the average of the individual battery voltages, total current equals the sum of the individual battery currents, the positive terminal of one battery is connected to the positive terminal of the next, the negative terminal of one battery is connected to the negative terminal of the next, and two connections are made between each adjacent battery.


2

Resistance is measured in:

86% Answer Correctly

amperes

coulombs

ohms

volts


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


3

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier converts an AC input to DC while an inverter converts a DC input to AC

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier converts a DC input to AC while an inverter converts an AC input to DC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


4

In electrical wiring, which of the following are proportional?

50% Answer Correctly

the length of the wire and the amount of the voltage

the diameter of the wire and the amount of the voltage

the diameter of the wire and the amount of the current

the length of the wire and the amount of the current


Solution

Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.


5

The electrical potential difference between two points is called:

60% Answer Correctly

conductance

resistance

current

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.