ASVAB Electronics Information Practice Test 971308 Results

Your Results Global Average
Questions 5 5
Correct 0 3.28
Score 0% 66%

Review

1

Which of the following is not a purpose of a resistor in an electrical circuit?

70% Answer Correctly

limit the current in the circuit

multiply the current in the circuit

moderate the heat in the circuit

control the voltage in the circuit


Solution

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.


2

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

\(P = {V \over I}\)

P = I2V

P = IV

\(P = {I \over V}\)


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


3

The ohm is a unit of measurement for:

81% Answer Correctly

power

resistance

capacitance

energy


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

A transistor works by allowing a small amount of current to control general current flow. Where is the small amount of current applied?

55% Answer Correctly

collector

input

base

emitter


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


5

Which of the following is not an advantage of semiconductors over conductors?

49% Answer Correctly

a semiconductor exhibits increased conductivity with increased temperatures

materials to produce semiconductors are cheap and abundant

a semiconductor conducts current better than a conductor

a semiconductor's conductivity can be varied under an external electrical field


Solution

A semiconductor is a material that has a limited ability to conduct electrical current with conductivity between that of an insulator and that of a conductor. Silicon, a cheap and abundant material, is the most used semiconductor material although other materials are used in the electronics components made from semiconductors. The primary advantages of a semiconductor over a conductor is that the conductivity of a semiconductor can be varied under an external electrical field giving engineers precise control over complex circuits and, unlike conductors like metals, a semiconductor's conductivity increases with increased temperatures.