Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.

A diode allows current to pass easily in one direction and blocks current in the other direction. A zener diode is a diode which allows current to flow in one direction as normal and will also allow current flow in the reverse direction when the voltage is above a certain value. This value is called the breakdown voltage.

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.

A fuse is a type of low resistance resistor that stops current flow in a circuit in response to a larger than intended electric current flow. Using a fuse with a higher current rating than required by a circuit is less safe as it could potentially allow overcurrent and risk a fire or heat-related equipment damage.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.