Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.

Current flow through a wire increases the temperature of the wire. If too small a wire is used, the wire will heat up causing a loss in conductivity and possibly a fire. The thicker in diameter a wire is, the more current it can carry without overheating.

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.

The purpose of a capacitor is to retain electric charge and it will do so even after its input voltage is removed. After the input voltage is removed, the capacitor will slowly discharge but, depending on the size and characteristics of the capacitor, discharging could take from a few minutes to a few years. So, it's never safe to touch a capacitor with your hands and you should make sure to discharge any capacitors in a circuit before working on it using an appropriately high-wattage resistor or a capacitor discharge tool.

A closed circuit is a complete loop or path that electricity follows. It consists of a source of voltage, a load, and connective conductors. If the circuit is interrupted, if a wire is disconnected or cut for example, it becomes an open circuit and no electricity will flow.