Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.