| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.66 |
| Score | 0% | 73% |
Which of the following is a difference between a circuit breaker and a fuse?
a fuse is cheaper than a circuit breaker |
|
all of these |
|
a circuit breaker can be reused |
|
a fuse responds more quickly than a circuit breaker |
Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.
| orthogonal | |
| perpendicular | |
| parallel | |
| series-parallel |
Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 54V 15A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 9V 90A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 27V 45A configuration.
The volt is a unit of measurement for:
capacitance |
|
power |
|
current |
|
voltage |
Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.
The ampere is a unit of measurement for:
current |
|
power |
|
inductance |
|
energy |
Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.
In a series circuit, which of the following is the same across all branches of the circuit?
current |
|
resistance |
|
conductance |
|
voltage |
A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.