ASVAB Mechanical Comprehension Practice Test 26469 Results

Your Results Global Average
Questions 5 5
Correct 0 2.94
Score 0% 59%

Review

1 If the radius of the axle is 5 and the radius of the wheel is 8, what is the mechanical advantage of this wheel and axle configuration?
41% Answer Correctly
0.63
8
3
1.6

Solution

The mechanical advantage of a wheel and axle is the input radius divided by the output radius:

MA = \( \frac{r_i}{r_o} \)

In this case, the input radius (where the effort force is being applied) is 5 and the output radius (where the resistance is being applied) is 8 for a mechanical advantage of \( \frac{5}{8} \) = 0.63


2

The force exerted on an object due to gravity is called:

69% Answer Correctly

density

potential energy

weight

mass


Solution

Mass is an intrinsic property of matter and does not vary. Weight is the force exerted on the mass of an object due to gravity and a specific case of Newton's Second Law of Motion. Replace force with weight and acceleration with acceleration due to gravity on Earth (g) and the result is the formula for weight: W = mg or, substituting for g, weight equals mass multiplied by 9.8 m/s2.


3

Which of the following is not a type of structural load?

50% Answer Correctly

occupancy load

live load

wind load

dead load


Solution

Dead load is the weight of the building and materials, live load is additional weight due to occupancy or use, snow load is the weight of accumulated snow on a structure and wind load is the force of wind pressures against structure surfaces.


4 If the green box weighs 40 lbs. and 60 lbs. of force is applied 3 ft. from the fulcrum at the blue arrow, how far from the fulcrum would the green box need to be placed to balance the lever?
55% Answer Correctly
1.13 ft.
13.5 ft.
4.5 ft.
2.25 ft.

Solution

To balance this lever the torques at the green box and the blue arrow must be equal. Torque is weight x distance from the fulcrum so the equation for equilibrium is:

Rada = Rbdb

where a represents the green box and b the blue arrow, R is resistance (weight/force) and d is the distance from the fulcrum.

Solving for da, our missing value, and plugging in our variables yields:

da = \( \frac{R_bd_b}{R_a} \) = \( \frac{60 lbs. \times 3 ft.}{40 lbs.} \) = \( \frac{180 ft⋅lb}{40 lbs.} \) = 4.5 ft.


5

Which of the following is not a type of bridge?

73% Answer Correctly

truss

arch

block

cable


Solution

The six basic bridge forms are beam, truss, arch, cantilever, cable, and suspension.