ASVAB Mechanical Comprehension Practice Test 337689 Results

Your Results Global Average
Questions 5 5
Correct 0 2.89
Score 0% 58%

Review

1 If the radius of the axle is 3 and the radius of the wheel is 6, what is the mechanical advantage of this wheel and axle configuration?
52% Answer Correctly
-3
0.5
2.0
3

Solution

The mechanical advantage of a wheel and axle is the input radius divided by the output radius:

MA = \( \frac{r_i}{r_o} \)

In this case, the input radius (where the effort force is being applied) is 6 and the output radius (where the resistance is being applied) is 3 for a mechanical advantage of \( \frac{6}{3} \) = 2.0


2

What type of load doesn't create specific stress points or vary with time?

59% Answer Correctly

non-uniformly distributed load

concentrated load

static uniformly distributed load

impact load


Solution

A concentrated load acts on a relatively small area of a structure, a static uniformly distributed load doesn't create specific stress points or vary with time, a dynamic load varies with time or affects a structure that experiences a high degree of movement, an impact load is sudden and for a relatively short duration and a non-uniformly distributed load creates different stresses at different locations on a structure.


3

Sam can do 50 ft. lb. of work in 2 minutes and 5 seconds. What would Sam have to do to increase his power output?

63% Answer Correctly

do the work in 2 minutes

do the work in 3 minutes

do 100 ft. lb. of work in 4 minutes 12 seconds

do 25 ft. lb. of work in 2 minutes 5 seconds


Solution

Power is the rate of doing work or \(\frac{W}{t}\). To increase power, increase the work being done in the same amount of time or do the same amount of work in less time.


4

Which of these will have the most impact on the kinetic energy of an object?

54% Answer Correctly

its speed

its direction

its mass

its weight


Solution

Kinetic energy is the energy of movement and is a function of the mass of an object and its speed: \(KE = {1 \over 2}mv^2\) where m is mass in kilograms, v is speed in meters per second, and KE is in joules. The most impactful quantity to kinetic energy is velocity as an increase in mass increases KE linearly while an increase in speed increases KE exponentially.


5

Which of the following is not a characteristic of a ceramic?

60% Answer Correctly

chemically stable

high melting point

low corrosive action

low density


Solution

Ceramics are mixtures of metallic and nonmetallic elements that withstand exteme thermal, chemical, and pressure environments. They have a high melting point, low corrosive action, and are chemically stable. Examples include rock, sand, clay, glass, brick, and porcelain.