ASVAB Mechanical Comprehension Practice Test 999991 Results

Your Results Global Average
Questions 5 5
Correct 0 3.45
Score 0% 69%

Review

1

What type of load doesn't create specific stress points or vary with time?

59% Answer Correctly

non-uniformly distributed load

concentrated load

impact load

static uniformly distributed load


Solution

A concentrated load acts on a relatively small area of a structure, a static uniformly distributed load doesn't create specific stress points or vary with time, a dynamic load varies with time or affects a structure that experiences a high degree of movement, an impact load is sudden and for a relatively short duration and a non-uniformly distributed load creates different stresses at different locations on a structure.


2

Which of these is the formula for force?

76% Answer Correctly

F = a/m

F = m/a

F = am2

F = ma


Solution

Newton's Second Law of Motion states that "The acceleration of an object as produced by a net force is directly proportional to the magnitude of the net force, in the same direction as the net force, and inversely proportional to the mass of the object." This Law describes the linear relationship between mass and acceleration when it comes to force and leads to the formula F = ma or force equals mass multiplied by rate of acceleration.


3

A fixed pulley has a mechanical advantage of:

68% Answer Correctly

2

0

-1

1


Solution

A fixed pulley is used to change the direction of a force and does not multiply the force applied. As such, it has a mechanical advantage of one. The benefit of a fixed pulley is that it can allow the force to be applied at a more convenient angle, for example, pulling downward or horizontally to lift an object instead of upward.


4

Gear ratio indicates which of the following about two connected gears?

59% Answer Correctly

power conversion

mechanical advantage

work done

efficiency


Solution

The mechanical advantage (amount of change in speed or torque) of connected gears is proportional to the number of teeth each gear has. Called gear ratio, it's the ratio of the number of teeth on the larger gear to the number of teeth on the smaller gear.  For example, a gear with 12 teeth connected to a gear with 9 teeth would have a gear ratio of 4:3.


5 50 lbs. of effort is used by a machine to lift a 300 lbs. box. What is the mechanical advantage of the machine?
84% Answer Correctly
5.4
6.6
6
9

Solution

Mechanical advantage is resistance force divided by effort force:

MA = \( \frac{F_r}{F_e} \) = \( \frac{300 lbs.}{50 lbs.} \) = 6